############################################################################# # Accretionary (fold-and-thrust) wedge over a weak basal decollement. # A small 2D version of the models of Lee, Tan & Chang (2024), # Front. Earth Sci. 12:1415139. Runs in a few minutes on 4 threads. # # A 3 km brittle layer over a 1 km weak decollement is pushed from the # left wall at 5 cm/yr over a fixed base. Only the basal friction angle # differs between wedge-phi1.cfg and wedge-phi5.cfg. ############################################################################# [sim] modelname = ramp-ov2 max_time_in_yr = 160000 # 8 km of shortening output_time_interval_in_yr = 10000 has_output_during_remeshing = no is_outputting_averaged_fields = no [mesh] meshing_option = 90 # mesh from a .poly file poly_filename = ramp-ov2.poly xlength = 40e3 ylength = 10e3 # unused in 2D zlength = 5e3 resolution = 250 largest_size = 4 smallest_size = 0.2 # tiny-element trigger; also the floor of dt quality_check_step_interval = 1000 min_quality = 0.3 remeshing_option = 12 # restore the pushing wall (x0) to vertical [control] surface_process_option = 1 surface_diffusivity = 1e-6 # hillslope diffusion, m^2/s inertial_scaling = 3e3 [bc] # Left wall: pushes at 5 cm/yr (1.5844e-9 m/s), shear velocity fixed at 0. # The push tapers linearly to 0 across the lowest 1 km (the decollement). vbc_x0 = 3 vbc_val_x0 = 1.5844e-9 bottom_shear_zone_thickness = 1e3 # in m # Right wall: free slip. Base: no slip. vbc_x1 = 1 vbc_val_x1 = 0 vbc_z0 = 3 vbc_val_z0 = 0 has_winkler_foundation = no has_water_loading = no surface_temperature = 273 mantle_temperature = 273 [ic] mattype_option = 0 # materials from the .poly regions weakzone_option = 0 [mat] rheology_type = elasto-plastic num_materials = 2 rho0 = [2600, 2600] alpha = [0, 0] bulk_modulus = [50e9, 50e9] shear_modulus = [30e9, 30e9] pls0 = [0, 0] pls1 = [0.1, 0.1] cohesion0 = [4e6, 4e6] cohesion1 = [4e5, 4e5] friction_angle0 = [30, 1] # basal friction angle: 1 degree friction_angle1 = [15, 1] dilation_angle0 = [0, 0] dilation_angle1 = [0, 0] min_viscosity = 1e24 # unused by elasto-plastic, but required