📄️ Plastic shear heating and sealed pressurization
A porous cell deforms at a prescribed pure-shear rate. Plastic work in aging rate-and-state plasticity heats the cell and expands the sealed fluid.
📄️ Groundwater heat transport: Ogata–Banks
Steady groundwater carries heat from a hot inlet along a saturated column while conduction spreads the front.
📄️ Thermal pressurization in a sealed cell
Uniform supplied heat warms a rigid, sealed porous material. The temperature rise and fluid expansion give independent heat and pressure references.
📄️ Heating a drained cell with changing water mass
All problems
📄️ Warm-water mixing in a drained cell
All problems
📄️ Thermal pressurization: McTigue surface heating
The drained surface of a fluid-saturated half-space is suddenly heated. Pore water expands more than the grains, so pressure rises below the surface while it drains upward, and the solid heaves.
📄️ Onset of hydrothermal convection: Horton–Rogers–Lapwood
Water in a porous box heated from below becomes lighter at the base. Above a critical Rayleigh number buoyancy overturns it into a convection cell; below it, a disturbance decays.
📄️ Steady hydrothermal convection: Nusselt number
Above onset the heated porous cell settles into a steady convection roll that carries several times the conductive heat flow. Its Nusselt number has no closed form; an independent fine-grid solution supplies it.
📄️ Three-dimensional porous convection cells
All problems
📄️ Transient plumes: Elder's heater problem
A porous layer heated from below over part of its base grows plumes that
📄️ Hot-water injection: Avdonin solution and heat ledger
Injected water carries its temperature. DES adds the injected enthalpy relative to the local temperature, which with fluid mass conservation makes its advective heat equation conserve energy. Two checks: radial hot-water injection against Avdonin’s solution, and a sealed doublet against an independent heat ledger.